Results 1 to 3 of 3

Thread: Freeway Overpass Test

  1. #1

    Freeway Overpass Test

    I used the extrude feature (after triangulating the slice to avoid nonconvex shapes). You also need to be careful which direction you extrude in as Maya sets normals up differently depending on the extrusion direction. The meshverify utility will let you know if the mesh is good or not.

  2. #2

    Re: Freeway Overpass Test

    Another shot, from the side[attachment=0:3aqbwidn][/attachment:3aqbwidn]

  3. #3

    Re: Freeway Overpass Test

    That was great!

    How many tets where there altogether?

Similar Threads

  1. Materials test
    By Etienne in forum Gallery
    Replies: 0
    Last Post: 10-27-2009, 03:11 AM
  2. a few DMM test runs.
    By Mallaien in forum Gallery
    Replies: 1
    Last Post: 08-11-2009, 03:39 AM
  3. UFO Crash Test
    By dmmjedi in forum Gallery
    Replies: 4
    Last Post: 10-07-2008, 11:45 AM
  4. Falling Glass Cube Test
    By dmmjedi in forum Gallery
    Replies: 11
    Last Post: 10-02-2008, 09:38 AM


Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts